Skip to Content

Legal Notice

Pleiger Plastics Company
498 Crile Road
Washington, PA 15301-1271

Phone 724-228-2244
Fax 724-228-2253
eMail: info@pleiger.com

The information contained on this site is based on our current knowledge and experience and does not exempt the user from carrying out their own comprehensive tests. This means that no legally binding warranty is given, including any warranty regarding the proprietary rights of third parties. The sale of our products is subject to our general terms and conditions of sale and delivery.

Disclaimer

1. Links:

The websites of Pleiger Plastics Company U.S.A. contain cross-references (hyperlinks) to websites of other vendors. During creation of the initial links the external sites were checked for illegal content. Pleiger Plastics Company U.S.A. assumes no responsibility for any external content that can be reached though such hyperlinks. If Pleiger Plastics Company U.S.A realize or is advised of such illegal content, the respective hyperlink will be removed if this is technically feasible and reasonable.

2. Use of our websites:

The content of the websites of Pleiger Plastics Company U.S.A. group is protected by copyright. Pleiger Plastics Company U.S.A. allow the viewing and downloading of all content solely for private, non-commercial purposes. The content must not be copied, presented, distributed or used in any other way for public or commercial purposes. The content must not be changed and used on other websites or networked computers without the written consent of Pleiger Plastics Company U.S.A..

3. Download:

Any download of programs and files is at the user’s own risk. Pleiger Plastics Company U.S.A. cannot be held liable for any damage resulting from the installation and/or use of software from the download section as far as this is permitted by law. Despite current checking for viruses any liability for damages and impairment due to computer viruses within the scope of legal regulations is excluded.

4. Guarantee and liability:

The information on our websites has been prepared with greatest care. At the same time, Pleiger Plastics Company U.S.A. strive to keep the information on this website up to date. However, Pleiger Plastics Company U.S.A. does not guarantee the completeness or suitability of the information for particular purposes. The use of the content provided on the websites is at the user’s own risk.

The liability of Pleiger Plastics Company U.S.A. in connection with the use of this website – no matter for which legal reason – is limited to damages caused by Pleiger Plastics Company U.S.A. or their vicarious agents or contractors by intent, gross negligence or, in case of violation of contractual obligations, by slight negligence. In cases of slight negligence, the liability of Pleiger Plastics Company U.S.A. is limited in its amount to typical and predictable damages for this type of business. Damage compensation claims resulting from warranties or according to the product liability act remain unaffected.

5. Trademark rights:

The owners of all trademarks used on the websites of Pleiger Plastics Company U.S.A. are indicated. Any use of these trademarks, logos and labels by third-parties is prohibited.

6. Security:

Pleiger Plastics Company U.S.A. place great importance on the security of your data. The transfer of user data via the Internet to Pleiger Plastics Company U.S.A. is only protected when the address line starts with https://www.xxxxxxx.com. In this case, the data transfer is securely protected against unauthorized reading by third parties through the SSL (Secure Socket Layer) communication protocol in connection with a 128 bit encryption. If this is not activated when sending further personal or proprietary information over the Internet using other applications such as e-mail the user should be aware that this is not a secure connection in the above sense.

7. Contact:

In case of further questions, please contact us under the above e-mail address.

Pleiger Plastics Company U.S.A. will continually strive to keep these terms of use up to date.

This version last updated 01 Nov 2011.